The Rebel Faction

Register today to customize your account.
Galactic Citizen

New Imperial Turbolaser System

The High Command of the Greatr Galactic Empire has decided to commence with a programme of rearming Imperial ships as such - an overhaul would be scheduled allowing th replacement of standard energy weapons (primarily turbolsers) with the new 'Stinger' System. The weapons themselves remain at their current power output and do not increase in range, rate of fire, or accuracy. The rearmament is for one purpose - to eliminate the affects of an ion barrage on the weaponry of an Imperial warship.

The Design Specifications are as Follows:

- Taken from Design Summary Briefing, Imperial High Command -

A new type of gun. Actually, it is a modification of existing turbolaser cannon in stock. It would not enable the turrets to rotate, but guns mounted in sponson and independently fire linked would still be able to fire. The pricniple I have devised goes to ship-borne cannon of the (Earth) early 20th Century.

Curretly, energy for the gun is transformed inside the breach of the gun and then sent through the tube unaccelerated merely guided in its discharge pattern. The energy release is then cut off and molded into a coherent bolt approximately one meter in length. It leaves the barrel and continues to its target. Without a power source, the energy cannot be created and built up, thus rendering the weapon useless.

I propose feeding the guns in small packages as it were. Cased shot. The casings would be approximatly four decimeters in width. From this circular baseplate would be a series of wound conducitivity spools. Energy would be stored in here, harnessed inside a carefully wrapped casing. The "shell" would be placed in the breach where the gun would suck dry the power and simply focus the energy as it left the barrel.

Each shell would only be able to be used once until it was recharged. The recharge process is lengthy and cannot be preformed on site - of the gun or battery. Rather, it would be performed deep in the ship so the power supply and feeding station could not be directly targeted by the enemy or ruptured by fire directed towards the using-ship's gunwales.

Electrivity would only be required on site, and as independent cannon are controlled either by manual aiming or droid-assisted positioning and only to focus the projectile's charge. The draw on individual generators would be minute, and in an emergency, a small personal generator used by the Imperial Army to set up command posts could be rigged to feed the guns.

Shells would be stored directly behind the guns themselves and transported from the innards of the ship. Keeping the shells in the ship's interior would, as stated, make all safer. They could be transported either by independent elevator or by repsulor dolley. One average strength man can hold and move the shells. They differ in size.

Cartridge Size
Light turbolaser - 25 centimeters
Medium/Standard Turbolaser - 30 centimeters
Heavy Turbolaser - 38 centimeters
Quad Turbolaser (Heavy Turret) - 42 centimeters


- Notice on Rotation During an Ion Strike -

Turreted guns would be shut down and unable to be moved-sighted during a strike as power to rotate comes from the main reactor. Moving the gun to a position would be near impossible, but could be done by dedicated gunners at great work. The guns are massive turreted enclosures, but can be moved a few meters left or right of its last position.

The casings give their all to guns mounted in sponson or the hull itself - ie, non turreted emplacements. These are moved manually or by droid.

Comments

#20 12:34am 16/09/03

Approved

#19 11:50pm 15/09/03

who is the other R and d moderator?????

Avatar
#18 3:06am 12/09/03

wait for your second approval

#17 2:50am 12/09/03

can we begin implementing this? or do I need to wait.

Avatar
#16 1:29am 12/09/03

APPROVED

#15 12:22am 12/09/03

yes. Each shell is a casing good for one shot. When the shot is fired, the gun recoils and ejects the spent casing onto the decking where it is removed by a crewmember for later refilling.

#14 3:25am 05/09/03

So, this clip powers the entire gun emplacement?

#13 12:24am 05/09/03

Small micro filament conducts wrapped continuously around a platsic central spine within the shell. The level of the intensity of the energy stored in the coil is based on the type of gun it is to be sued in.

#12 12:22am 05/09/03

I don't see how your method will keep the cannon itself from becoming effected by an ION blast. Sure, the clip won't be hurt, but the gun needs energy to fire (not charge, but fire the bolt), pivot, target, and cool equipment amongst other things.

Avatar
#11 11:17pm 04/09/03

How is the energy stored?

#10 11:05pm 04/09/03

So what is your decision? Any questions I can answer further?

Avatar
#9 2:55am 03/09/03

yes he did, my bad, I had too many things doin to realize, lol

#8 2:16am 03/09/03

I think he was responding ot your question about reloading shells.

Avatar
#7 2:11am 03/09/03

I think we need a translator here... he doesnt seem to understand the questions were asking...

#6 2:04am 03/09/03

yes. I have added in defects, however, so it does not seem as if we are god moding.

- The shells themselves are volatile. While they can survive the basic handling of a gun in action, they do not react well to explosions. Thus the magazines are kept deep within the ship and shells are brought up by conveyors and teams of men and droids using grav sleds.

- As well, the reloading process of the canisters takes a great deal of time and a dedicated generator. The process is rather time consuimg and this reacotr is even more volatile than the shells themselves.

12>>>